![]() Now you can turn them a bit to each side to make sure everything is working as it should, and get the strings back in place. Now that you’ve secured your new tuning machines in place, tighten the hex nut over the metal ring. Move the backplate around a bit to find the right spots for the screws and screw them back in.Insert the metal ring and the hex nut on the shaft, but don’t tighten it too much yet, leave some room for adjusting the screws in the back.Insert the tuning pegs on the headstock hole.Now that you got the right tuners to replace the broken/old ones, this is how to go about it: Using a common ruler, measure the diameter of the holes in your headstock so you can get the right ones for your guitar.Īs a general rule, the measure is around 10 mm (13/32”), but in older guitars, this might be a bit smaller. This is a good opportunity to remove any dirt that has accumulated under the tuning pegs, since these are very hard-to-reach places, and you won’t be performing this kind of maintenance too often. After that, remove the metal ring under it as well.Īt this point, your old guitar knob should come off easily. You can use a small or an adjustable wrench to get the nut loose and take it off. Under the hole where the strings go in the tuning machine, you will often find a hex nut and a metal ring under it. Remove the Hex nut and metal ring on the front side Pay attention to their length though, since if they are too long you might end up damaging the paint and finish in the front side of the headstock,.Set aside the screws so you can use them to reattach the new ones, or if you need you can use new ones too.Depending on the tuner model, they will vary in quantity but are usually 2-4 screws per peg, and most times you will be able to do this with a small Phillips screwdriver.The second step is to locate the screws that attach the tuning peg to the headstock. ![]() Remove screws on the back of neck removing the screws of the tuner in the back of the headstock If you have chosen and bought new tuner knobs already, let’s move on to actually replacing them on your instrument. There are other types of tuners you can get depending on your instrument, and they’ll either expand the possibilities (like those cool ones that allow you to lower a half-step using a lever) or simply enhance your guitar aesthetically. Standard tuning pegs usually have this terrible problem with the lower strings slipping when you’re trying to tune, or right after you started playing. This is helpful when your guitar won’t stay in tune for long Locking tuners are awesome They come with a locking screw on the back and it’ll press against the string inside the tuner hole, keeping it in place while you tune. If you’re considering upgradingfrom your current model, a great choice is to install new locking tuners. Options – How to Replace Broken Guitar Tuning Knobs We will get to measuring the hole in a couple of paragraphs, and concerning the screws, you can simply check online if the new tuners will match the current ones. When looking for replacement guitar tuners, you must pay attention to the diameter of the hole in your guitar, and the location of the screws in the back of the knob. While they may seem complicated at first, the procedure to replace a guitar turning knob isn`t too difficult and doesn’t carry many risks to your instrument, if you take proper care when executing it. The good news is that a set of good guitar pegs won’t be too expensive, and you can seize the opportunity to upgrade to better ones, that will hold your guitar in tune while offering other functionalities like locking the string in place.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |